山東裝載機http://www.jmkey.cn/圓弧齒輪綜合曲率半徑比漸開線齒輪傳動大很多，其接觸強度比漸開線齒輪傳動約高0.5～1.5倍；兩輪齒沿嚙合線方向的滾動速度很大，齒面間易于形成油膜，傳動效率較高，一般可達0.99～0.995。
Shandong comprehensive than the radius of curvature of the loader arc gear involute gear drive many large, high-contact transmission strength of about 0.5 to 1.5 times higher than involute gear; two teeth meshing line along the direction of the scrolling speed is large, between the tooth surface easy to form a film, high transmission efficiency, usually ranging from 0.99 to 0.995.

山東裝載機圓弧齒輪是裝載機配件中的一部分，工作是沿齒高方向磨損均勻，且容易跑合，無根切現象，故最小齒數可以少。齒輪對中心距、切齒深度和螺旋角的誤差敏感性很大，這三項誤差對承載能力影響較大，故圓弧齒輪對制造和安裝精度要求較高。
Shandong loader loader accessories arc gear is part of the work is high along the direction of the tooth wear uniform, and easy to run together, without undercutting phenomenon, it is the smallest number of teeth can be less. Gear to

center distance, Cutting error sensitivity of great depth and helix angle, the larger of the three errors on the carrying capacity, so arc gear on the manufacture and installation of high precision.

山東裝載機http://www.jmkey.cn/圓弧齒輪的操作允許有誤差的存在，但誤差不能太大，要求安裝精度，工作對精度的要求也比較嚴格，盡量將誤差控制在最小的范圍內。
Shandong loader operation arc gear allows the existence of error, but the error is not too large, require the installation of precision, accuracy requirements are more stringent, as the error control in the smallest range.